In order to activate the touch-sensitive knobs on your MASCHINE STUDIO controller, please follow these steps:
- Make sure MASCHINE 2.2 or higher is installed on your computer. You will find this update in Native Access or in the Personal Update Manager on our website.
Note: This feature requires Controller Editor version 1.7.3 or higher. It is installed by default with the MASCHINE 2.2 update. Do not deselect the Controller Editor during the installation process.
- Make sure the latest firmware update is installed for your MASCHINE STUDIO controller. To install the latest firmware update, please run the latest Device Updater for MASCHINE STUDIO which you will find here on our website. For detailed instructions on updating the firmware, please read How to Update the Firmware of your NI Audio Interface or Controller from our Knowledge Base.
Next time you start the MASCHINE software, the touch-sensitive knobs features on your MASCHINE STUDIO controller will work as expected.
Important note: The touch-sensitive knobs are only available on the MASCHINE STUDIO hardware.