In the Monitor section of the KOMPLETE AUDIO 6 audio interface, you can set the device to bypass any signal processing and send the audio signal from the input directly to the output of the device at zero latency. This function is known as Direct Monitoring.
Note: The Direct Monitoring feature only applies to inputs 1/2 and is not available for inputs 3/4 and 5/6.
You can activate Direct Monitoring via the ON switch in the Monitor section, located in the front panel of the KOMPLETE AUDIO 6. This routes the signal of the inputs 1 and 2 directly to the selected outputs. The ON switch also doubles as an output Monitor selector switch. When held for one second, it cycles through three Monitor modes:
- Monitor signal to outputs 1/2
- Monitor signal to outputs 3/4
- Monitor signal to both output pairs 1/2 and 3/4
The LEDs on the device's top panel display which monitoring mode is currently active.