S4 mk3 controls require calibration [en-us]

Pinned Open

Comments

121 comments

  • Avatar
    Las @ NI

    Hi all,

    Please follow the instructions available on page 1 of this post.

    As a refresher, here they are also:

    Important Note: Please read this message thoroughly before you apply the steps. Any carelessness may result in additional mis-calibration!

    What will happen now?

    You will need to download and run (not install) a Traktor build which will be used only for the recalibration. Please do the following:

    Installation
    the user must do the following steps to recalibrate his unit:

    • make sure the official version Traktor Pro 3.2.1  is installed and authorized on the computer
    • download the Traktor Pro 3.2.1 build from the link below, unpack it and launch it via double-click
    • connect and power-on the S4MK3
    • in Traktor go to Preferences > S4MK3 > Calibration
    • Chose to either calibrate the upper FX units or the entire Mixer Section and follow the instructions



    Note: all knobs of a section must be calibrated.  Omitting individual knobs will result in mis-calibration of these individual knobs.

    The calibration data is stored in the S4MK3 so that after successful calibration, therefore please discard the special Traktor build and continue using the installed official version 3.2.1
    Resources:

    Mac
    Kontrol S4 Mk3 3.2.1 Calibration Beta - MAC
    Win
    Kontrol S4 Mk3 3.2.1 Calibration Beta - WIN

     
    -1
    Comment actions Permalink

Post is closed for comments.