Traktor 3.2.1 / S4mk3 tempo fader issue

置顶的 Answered

Kevin Harman

2019年10月30日 12:55

Yesterday I updated to Traktor 3.2.1. Afterwards I have noticed that on my S4mk3 that there is a large zone on the tempo fader where the neutral Tempo LED is on: +/- 0.5%. This was not the case before the update. It is difficult enough to quickly go to 0% tempo offset without a detent position on the fader. Now it is even worse without an accurate LED indicator. Can this please be fixed in your upcoming 3.3 release. If I am missing a new setting in the preferences that can adjust this zero range then my apologies and please steer me in the right direction. Thank you. Regards, Kevin

7 条评论

正式评论

Mark @ NI 2019年11月13日 11:39 (已编辑于 2019年11月13日 11:45)

Hi Kevin, hi muthafunka,

thanks a lot for drawing our attention to this phenomenon! I have tested the behavior and could fully reproduce the reported problem. Therefore I have filed the following issue to our developers:

TP-14068 - S4MK3 Neutral Zone Faulty in Relative Tempo Fader Mode (Win only)

I will update this thread once the fix is available. For the time being, the workaround is a roll-back to your previously used version as described here:

How Can I Downgrade my TRAKTOR to an Earlier Version?

This thread is temporarily closed and will be reopened once there is news.

评论操作固定链接
muthafunka 2019年11月03日 08:30 (已编辑于 2019年11月03日 08:31)

Yep, same here, came here looking for info about this exact same problem ;(

Tried the calibration tool but it doesn't cover the tempo fader.

come on NI...you can do it!

0

评论操作固定链接
Daniel @ NI 2019年11月06日 13:24 (已编辑于 2019年11月06日 13:25)

Hello you two,

Are you on MAC or PC?

Do you both have the latest firmware on the S4 mk3 Firmware Updater for Traktor Kontrol S4 MK3 1.3.0 Mac /Firmware Updater for Traktor Kontrol S4 MK3 1.3.0 Win ?

1

评论操作固定链接
Kevin Harman 2019年11月06日 13:51

Hi Daniel,

I am using a PC. I believe that I have the latest S4mk3 firmware installed. Doesn't Traktor do a check now to make sure that the latest firmware is present? When I installed Traktor 3.2.1 I did not get a message that my firmware needed updating.

Cheers,

Kevin

0

评论操作固定链接
Kevin Harman 2019年11月06日 13:54

BTW, I took a short video of this that may help you, but there doesn't seem to be a way for me to upload it here.

0

评论操作固定链接
muthafunka 2019年11月06日 14:57

Hi Daniel,

I'm on Mac and had/have the latest firmware installed and also the latest TP3.

0

评论操作固定链接
Daniel @ NI 2019年11月07日 16:34

Hello,

I created a ticket for both of you and forwarded to our Traktor specialists, They will get back to you as soon as possible.

1

评论操作固定链接

帖子评论已关闭。

评论

How Can I Downgrade my TRAKTOR to an Earlier Version?

没有找到您要找的？